[300-101 Free Questions] 300-101 Implementing Cisco IP Routing

1. Which three problems result from application mixing of UDP and TCP streams within a network with no QoS? (Choose three.)

2. Which statement about the use of tunneling to migrate to IPv6 is true?

3. Which two actions must you perform to enable and use window scaling on a router?(Choose two.)

4. A network administrator executes the command clear ip route.

Which two tables does this command clear and rebuild? (Choose two.)

5. Under which condition does UDP dominance occur?

6. Refer to the exhibit.

A network administrator checks this adjacency table on a router.

What is a possible cause for the incomplete marking?

7. A network administrator uses IP SLA to measure UDP performance and notices that packets on one router have a higher one-way delay compared to the opposite direction.

Which UDP characteristic does this scenario describe?

8. Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

9. Which switching method is used when entries are present in the output of the command show ip cache?

10. Refer to the exhibit.

Based on this FIB table, which statement is correct?

11. Which three TCP enhancements can be used with TCP selective acknowledgments?(Choose three.)

12. A network engineer notices that transmission rates of senders of TCP traffic sharply increase and decrease simultaneously during periods of congestion.

Which condition causes this?

13. A corporate policy requires PPPoE to be enabled and to maintain a connection with the ISP, even if no interesting traffic exists.

Which feature can be used to accomplish this task?

14. Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?