CCNP Collaboration 300-815 CLACCM Exam Questions

Through the feedback of many examinees who have used PassQuestion CCNP Collaboration 300-815 CLACCM Exam Questions to pass Implementing Cisco Advanced Call Control and Mobility Services (CLACCM) exam, it proves that using PassQuestion products to pass IT certification exams is very easy. Recently, PassQuestion has developed the newest CCNP Collaboration 300-815 CLACCM Exam Questions, including some pertinent simulation tests that will help you consolidate related knowledge and let you be well ready for Cisco 300-815 exam.

CCNP Collaboration 300-815 CLACCM Exam Questions – Implementing Cisco Advanced Call Control and Mobility Services (CLACCM)

1. Refer to the exhibit.

In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.

Which two scenarios are correct? (Choose two.)

 
 
 
 
 

2. Refer to the exhibit.

Users report that when they dial to Cisco Unity Connection from an external network, they cannot enter any digits. Assuming only in-band DTMF is supported, what is a reason for this malfunction?

 
 
 
 

3. The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses H.323 protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real-Time Transport Protocol traffic that had the one-way audio call.

You gather the H.225 and H.245 messages for one of the one-way audio calls.

Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).

 
 
 
 

4. Which two extended capabilities must be configured on dial peers for fast start-to-early media scenarios (H.323 to SIP interworking)? (Choose two.)

 
 
 
 
 

5. When you troubleshoot H.323 call setup, which message informs you that the called party is being notified about the call?

 
 
 
 

6. End users at a new site report being unable to hear the remote party when calling or being called by users at headquarters. Calls to and from the PSTN work as expected.

To investigate the SIP signaling to troubleshoot the problem, which field can provide a hint for troubleshooting?

 
 
 
 

7. Why would RTP traffic that is sent from the originating endpoint fail to be received on the far endpoint?

 
 
 
 

8. An administrator is troubleshooting call failures on an H.323 gateway via the CLI.

To see signaling for media and call setup, which debug must the Administrator turn on?

 
 
 
 
 

9. What is first preference condition matched in a SIP-enabled incoming dial peer?

 
 
 
 

10. Cisco SIP IP telephony is implemented on two floors of your company. Afterward, users report intermittent voice issues in calls established between floors. All calls are established, and sometimes they work well, but sometimes there is one-way audio or no audio. You determine that there is a firewall between the floors, and the administrator reports that it is allowing SIP signaling and UDP ports from 20000 to 22000 bidirectionally.

What are two possible solutions? (Choose two.)

 
 
 
 
 

Cisco 300-620 DCACI Exam Questions - Implementing Cisco Application Centric Infrastructure
300-635 DCAUTO Exam Questions - Automating and Programming Cisco Data Center Solutions

Leave a Reply

Your email address will not be published. Required fields are marked *