CCNP Security 300-730 SVPN Practice Test Questions

The Implementing Secure Solutions with Virtual Private Networks v1.0 (SVPN 300-730) exam is a 90-minute exam associated with the CCNP Security, and Cisco Certified Specialist – Network Security VPN Implementation certifications. This exam tests a candidate’s knowledge of implementing secure remote communications with Virtual Private Network (VPN) solutions including secure communications, architectures, and troubleshooting.

PassQuestion provides you the latest CCNP Security 300-730 SVPN Practice Test Questions, which have have a very close similarity with real exam. PassQuestion can promise that you can 100% pass your first time to attend Cisco 300-730 exam.Through PassQuestion you can get the latest CCNP Security 300-730 SVPN Practice Test Questions. Please purchase it earlier, it can help you pass your first time to participate in the Cisco 300-730 exam.

CCNP Security 300-730 SVPN Practice Test Questions – Implementing Secure Solutions with Virtual Private Networks (SVPN)

1. A second set of traffic selectors is negotiated between two peers using IKEv2.

Which IKEv2 packet will contain details of the exchange?

 
 
 
 

2. On a FlexVPN hub-and-spoke topology where spoke-to-spoke tunnels are not allowed, which command is needed for the hub to be able to terminate FlexVPN tunnels?

 
 
 
 

3. Which statement about GETVPN is true?

 
 
 
 

4. Refer to the exhibit.

Which two tunnel types produce the show crypto ipsec sa output seen in the exhibit? (Choose two.)

 
 
 
 
 

5. Which two changes must be made in order to migrate from DMVPN Phase 2 to Phase 3 when EIGRP is configured? (Choose two.)

 
 
 
 
 

6. Refer to the exhibit.

A customer cannot establish an IKEv2 site-to-site VPN tunnel between two Cisco ASA devices.

Based on the syslog message, which action brings up the VPN tunnel?

 
 
 
 

7. Which two parameters help to map a VPN session to a tunnel group without using the tunnel-group list? (Choose two.)

 
 
 
 
 

8. Which method dynamically installs the network routes for remote tunnel endpoints?

 
 
 
 

9. Which command identifies a Cisco AnyConnect profile that was uploaded to the flash of an IOS router?

 
 
 
 

10. Refer to the exhibit.

Which value must be configured in the User Group field when the Cisco AnyConnect Profile is created to connect to an ASA headend with IPsec as the primary protocol?

 
 
 
 

300-735 Practice Test Questions - Automating and Programming Cisco Security Solutions (SAUTO)
Cisco CLAUTO 300-835 Exam Questions - CCNP Collaboration and Cisco Certified DevNet Professional certification

Leave a Reply

Your email address will not be published. Required fields are marked *

➤