Cisco 350-501 SPCOR Free Questions – New CCNP Service Provider and CCIE Service Provider Core Exam

1. Refer to the exhibit.

P3 and PE4 are at the edge of the service provider core and serve as ABR routers. Aggregation areas are on either side of the core.

Which statement about the architecture is true?

2. Which component is similar to an EVPN instance?

3. Why do Cisco MPLS TE tunnels require a link-state routing protocol?

4. Refer to the exhibit.

BGPsec is implemented on R1, R2, R3, and R4. BGP peering is established between neighboring autonomous systems.

Which statement about implementation is true?

5. You are configuring MPLS traffic-engineering tunnels in the core.

Which two ways exist for the tunnel path across the core? (Choose two.)

6. Which configuration mode do you use to apply the mpls ldp graceful-restart command in IOS XE Software?

7. After you analyze your network environment, you decide to implement a full separation model for Internet access and MPLS L3VPN services.

For which reason do you make this decision?

8. Which statement about the Cisco MPLS TE forwarding adjacency feature is true?

9. While implementing TTL security, you issue the PE(config-router-af)#neighbor 2.2.2.2 ttl-security hops2 command.

After you issue this command, which BGP packets does the PE accept?

10. Refer to the exhibits.

Which information is provided for traceback analysis when this configuration is applied?

11. Refer to the exhibit:

This output is included at the end of an output that was provided by a device using NETCONF.

What does the code show?

12. Refer to the exhibit:

If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?

13. Which configuration mode do you use to apply the mpls Idp graceful-restart command in IOS XE Software? MPLS

14. Which statement describes the advantage of a Multi-Layer control plane?

15. Refer to the exhibit:

R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed.

When the debug ip ospf hello command is issued on R1. these log messages are seen.

Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?

16. Refer to the exhibit:

It the NetFlow configuration is updated to version 9, which additional piece of information can be reported"?

17. Which configuration modifies Local Packet Transport Services hardware policies?

A)

B)

C)

D)

18. Refer to the exhibit:

Which effect of this configuration is true?

19. Refer to the exhibit:

An engineer is preparing to implement data plane security configuration.

Which statement about this configuration is true?

20. Refer to the exhibit:

Which statement supports QPPB implementation?

21. Refer to the exhibit.

An engineer is configuring two routers to support MPLS LDP sessions between them. The R1 configuration is complete, and work has started on R2 as shown.

Which additional configuration must the engineer apply to R2 to complete the task?

22. Refer to the exhibit:

You are configuring an administrative domain implement so that devices can dynamically learn the RP?

23. Which protocol does a Cisco MPLS TE tunnel use to maintain paths within the core?

24. Refer to the exhibit:

Which three outcomes occur if the prefix list is added to the neighbor? (Choose three)

25. Refer to the exhibit:

Which statement about the neighbor statements for 192.168.1.1 is true?

26. Refer to the exhibit:

Assume all other configurations are correct and the network is otherwise operating normally.

Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

27. Drag and drop the OSs from the left onto the correct descriptions on the right.

28. Refer to the exhibit:

Router R1 and its peer R2 reside on the same subnet in the network, If does it make connections to R2?

29. Refer to the exhibit:

What is the URL used for with REST API?

30. Which statement about segment routing prefix segments is true?

31. Which component is similar to an EVPN instance?

32. Refer to the exhibit:

BGP sec is implemented on R1. R2. R3. and R4 BGP peering is established between neighboring autonomous systems.

Which statement about implementation is true?

33. Refer to the exhibit:

A network engineer is implementing a BGP routing policy.

Which effect of this configuration is true?

34. Refer to the exhibit:

Which statement describes this configuration?

35. Which task must be performed first to Implement BFD in an IS-IS environment?

36. A network engineer is configuring a BGP route policy for the SUBNET prefix set. Matching traffic must be dropped, and other traffic must have its MED value set to 400 and community 4:400 added to the route.

Which configuration must an engineer apply?

37. Refer to the exhibit.

What is the result of this configuration?

38. Why do packet loops occur during the configuration of BlDlR-PIM?

39. Which statement about the Cisco MPLS TE forwarding adjacency feature is true?

40. Refer to the exhibit:

Which statement about the status of the neighbor relationship between R1 and R2 is true?

41. Which BGP attribute is used first when determining the best path?

42. Which two uses of the YANG data modeling language are true? (Choose two)

43. Refer to the exhibits:

R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically.

Based on this output, which statement is true?

44. Refer to the exhibit:

A network administrator wants to enhance the security for SNMP for this configuration.

Which action can the network administrator implement?

45. While implementing TTL security, you issue the PE (config-router-af)#neighbor 2.2.2.2 ttl-security hops 2 command.

After you issue this command, which BGP packets does the PE accept?

46. What does DWDM use to combine multiple optical signals?

47. Drag and drop the NAT64 descriptions from the left onto the correct NAT64 types on the right.

48. Refer to the exhibit:

Which command is used to complete this configuration for QoS class-based marking?

49. Refer to the exhibit:

This configuration is being applied on an IOS XR router.

Which statement about this configuration is true?

50. Which two IS-IS parameters must match before two Level 2 peers can form an adjacency? (Choose two)