DELL EMC DES-1241 Exam Questions For Specialist – Platform Engineer, PowerStore – PassQuestion Free Questions To Test Online

1. What describes Dell EMC PowerStore X front-end cabling?

Uses internal VMware virtual switching and does not require a management network

Storage and management use the same LACP bonded cable connection

Uses VLTi data switch interconnectivity to support vMotion networks

Management and discovery use the same cables and connections as storage

2. Through which network do external hosts connect to the cluster for data access?

Management

ICM

ICD

Storage

3. A Storage Administrator is adding an appliance into an existing Dell EMC PowerStore T cluster.

What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?

All the needed management IP addresses for the new appliance must be pre-configured on the cluster

Additional appliance does not require a cluster management IP address

Additional appliance inherits all its management IPs from the existing appliance

All the needed management IP addresses for the new appliance are auto-generated by the cluster

4. What describes the power requirements for Dell EMC PowerStore?

Lower model numbered systems require less AC line current than higher model numbered systems

T models require less total power than X models

X models require less total power than T models

Lower model numbered systems require less input voltage (VAC) than higher model numbered systems

5. What is the last step when adding a drive to a Dell EMC PowerStore system?

Verify the new drive is seen

Add the drive to the pool

Backup the keystore

Zero the drive

6. Refer to the exhibit.

A Storage Administrator is troubleshooting a Dell EMC PowerStore T hardware issue. They observe that the base enclosure LED circled is blue.

What does this indicate?

Base enclosure hardware is operating normally

Base enclosure has a component hardware fault

Cluster has only a single appliance

Appliance has a node in service mode

7. A Storage Administrator needs to connect through SSH to run svc commands.

How is the SSH session configured?

Appliance IP address using port 22

NAS server IP address using port 26

NAS server IP address using port 22

Appliance IP address using port 26

8. Which port is used to SSH from one Dell EMC PowerStore appliance to another?

443

9. During Dell EMC PowerStore startup, both appliance nodes have rebooted in service mode.

What must be done first to avoid management software conflicts?

Reboot node B

Clear the boot mode

Disable node B boot mode

Return node A to normal mode

10. Refer to the exhibit.

What is the result of the network configuration shown for a Dell EMC PowerStore T?

Interfaces are configured for remote replication traffic

Interfaces are configured for PowerStore discovery traffic

Ports 1/1/55 and 1/1/56 are added to a new LACP domain

Ports 1/1/55 and 1/1/56 are added to the VLTi domain

DELL EMC DES-1241 Exam Questions For Specialist – Platform Engineer, PowerStore

DELL EMC DES-1241 Exam Questions For Specialist – Platform Engineer, PowerStore

Leave a Reply Cancel reply