H31-341 Free Questions – HCIP-Transmission V2.0 – PassQuestion Free Questions To Test Online

1. Which of the following descriptions are correct about the ASON software structure? (Multiple Choice)

Intelligent optical network consists of three planes

The management plane mainly refers to upper management such as network management.

Intelligent software mainly apply for management plane

The transmission plane refers to the traditional transmission network.

2. The transmission plane mainly performs functions such as optical signal transmission, multiplexing, configuration protection switching and cross-connection. And to ensure the reliability of the transmitted optical signal. However, the exchange action of this layer is carried out under the influence of the management dry surface and the control plane.

TRUE

FALSE

3. Which of the following are limitations of the alarm and performance analysis methods? (Multiple Choice)

Field maintenance personnel cannot understand the current operation status of the equipment.

The network administrator cannot obtain the alarms, the alarm occurrence time, and the historical alarms of the device.

When some faults occur, there may be no obvious alarms or performance events reported, and sometimes no alarms or performance events are found.

In the case of complex networking, service, and fault information, a large number of alarms and performance events may occur along with the occurrence of faults. Due to too many reports and performance events, maintenance personnel are unable to analyze.

4. Which of the following data is the data that needs to be collected and saved in the event of a failure? (Multiple Choice)

Equipment alarms and performance events

Running status data of the NE and the board

Operation log of the network management

Configuration data of NEs and boards

5. When the signal of the standard Ethernet frame length of 64 Bytes is connected to the Ethernet board, if the QinQ function is enabled, how many bytes is the actual frame length of the signal inside the board?

6. Which of the following ROADM boards have WSS optical modules? (Multiple Choice)

WSMD9

WSD9

WSM9

RDU9

7. Which of the following device types support the master-slave sub-architecture mode? (Multiple Choice)

OSN 8800

OSN 1800V

OSN 9800

8. What are the ways that NG WDM devices create fibers? (Multiple Choice)

Search method

Graphic method

Synchronization method

Form method

9. Which of the following paths can be configured on the network management? (Multiple Choice)

Client

ODUk

OTS

OCh

10. Path method creates OCh failure, what are the possible reasons? (Multiple Choice)

There are still unremoved alarms in the boards involved in OCh.

Inconsistent wavelength setting at both ends of source and sink

No service layer path

Some pigtails are not connected

H31-341 Free Questions – HCIP-Transmission V2.0

H31-341 Free Questions – HCIP-Transmission V2.0

Leave a Reply Cancel reply