H35-520-ENU Free Questions – Huawei Certified Network Associate-WCDMA RNP&RNO – PassQuestion Free Questions To Test Online

1. In WCDMA system, which criterion is the cell selection based on?

C1 criterion

H criterion

S criterion

R criterion

2. There are two methods for measuring the uplink load in WCDMA system. What are they?

Load statistics and throughput-based load estimation based on wideband receive power levels

Based on BLER statistics based on throughput and load statistics

Based on BLER statistics based on broadband and received power level of the load statistics

All above are not correct

3. The uplink load of the WCDMA cell is 50%, what is the size of corresponding noise rises when compared with no load?

3dB

4dB

6dB

9dB

4. Different diversity combining method to improve reception of different, the following types of combining methods, of which is not the most obvious improving effect?

Maximum ratio merger

Choice ratio merger

Equal gain merger

The above are almost the same

5. For the PS service, which of the following is a parameter describing the PS service?

BHSA, Packet Call Numbers/Session, Packet Number/Packet Call, Packet size

BHSA, BHCA, Packet Number/Packet Call, Packet size

BHCA, AHT, Packet Number/Packet Call, Packet size

BHCA, Active Factor, Packet Number/Packet Call, Packet size

6. Engineers need to prepare for the road test before they are ready to conduct a road test on a network that has been officially put into commercial operation. Which of the following tasks is not required?

Check if there is a network device alarm

Check the cell status

Simulated load loading

Test route selection

7. Which of the following statement is wrong about the road test?

Check the road test instrument before the road test.

The location of the road test terminal antenna has little effect on the road test results.

The speed of the vehicle has a certain influence on the road test results.

The choice of road test route has a certain impact on the road test results.

8. Which statement is wrong about the downward inner loop power control and the uplink inner loop power control?

The inner loop power control of the uplink channel and the downlink channel compares the received signal to noise ratio with a preset target signal to noise ratio (SIRtarget).

The maximum rate of inner loop power control of the uplink channel and the downlink channel is 1.5 kHz.

The inner loop power control of the uplink channel and the downlink channel is directly performed at the physical layer.

The inner loop power control of the uplink channel and the downlink channel are mainly to overcome the near-far effect

9. The transport block size selected for UE scheduling in category 12 is 3440bit. What is the transmission rate of MAC-HS layer?

344Kbps

384Kbps

1720Kbps

2048Kbps

10. For cells with limited uplink capacity, the use of towers can improve capacity constraints.

True

False

H35-520-ENU Free Questions – Huawei Certified Network Associate-WCDMA RNP&RNO

H35-520-ENU Free Questions – Huawei Certified Network Associate-WCDMA RNP&RNO

Leave a Reply Cancel reply