New CWNA-108 Exam Questions Available

1. An RF signal sometimes bends as it passes through some material other than free space.

What is the term that describes this behavior?

Refraction

Warping

Scattering

Reflection

2. What can an impedance mismatch in the RF cables and connectors cause?

Increased range of the RF signal

Fewer MCS values in the MCS table

Increased amplitude of the RF signal

Excessive VSWR

3. What factor does not influence the distance at which an RF signal can be effectively received?

Receiving station’s radio sensitivity

Receiving station’s output power

Transmitting station’s output power

Free Space Path Loss

4. A WLAN transmitter that emits a 50 mW signal is connected to a cable with 3 dB loss.

If the cable is connected to an antenna with 9dBi gain, what is the EIRP at the antenna element?

26 dBm

13 dBm

23 dBm

10 dBm

5. In a long-distance RF link, what statement about Fade Margin is true?

A Fade Margin is unnecessary on a long-distance RF link if more than 80% of the first Fresnel zone is clear of obstructions.

The Fade Margin is a measurement of signal loss through free space and is a function of frequency and distance.

Fade Margin is an additional pad of signal strength designed into the RF system to compensate for unpredictable signal fading.

The Fade Margin of a long-distance radio link should be equivalent to the receiver’s low noise filter gain.

6. What wireless networking term describes the increase of RF energy in an intentional direction with the use of an antenna?

Directed Radiation

Beam Digression

Passive Gain

Active Amplification

7. Which directional antenna types are commonly used by indoor Wi-Fi devices in a MIMO multiple spatial stream implementation?

Dipole and yagi

Grid and sector

Patch and panel

Dish and grid

8. What statement about the beamwidth of an RF antenna is true?

Horizontal and vertical beamwidth are calculated at the points where the main lobe decreases power by 3 dB.

The beamwidth patterns on an antenna polar chart indicate the point at which the RF signal stops propagating.

When antenna gain is lower, the beamwidth is also lower in both the horizontal and vertical dimensions.

Vertical beamwidth is displayed (in degrees) on the antenna’s Azimuth chart.

9. Which one of the following is not a factor considered when calculating the Link Budget for an outdoor point-to-point WLAN bridge link?

Operating frequency

MU-MIMO capabilities of the bridges

Receive antenna gain

Transmit power

10. What best describes WPA2 in relation to 802.11 wireless networks?

WPA2 is the standard that defines security for WLANs.

WPA2 is a certification created by the Wi-Fi Alliance that validates devices correctly implement CCMP/AES.

WPA2 is the second version of WPA and it enhances security through the use of TKIP instead of WEP.

WPA2 is specified in the 802.11 standard as implementing CCMP/AES.

New CWNA-108 Exam Questions Available – CWNA-107 Exam Will Be Retired

Leave a Reply Cancel reply